Kirkwood HVAC & Plumbing Services

Responded to no cooling complaint on 10+ year old Lennox residential air conditioning system. Upon arrival, confirmed indoor temperature at 90 degrees with outdoor condenser fan motor inoperative. Diagnosed failed condenser fan motor preventing heat rejection from refrigeration cycle. Accessed condenser unit, tested electrical components, and replaced defective fan motor to restore proper system operation and cooling capacity.

Responded to building drain blockage affecting office AC unit condensate drainage. Accessed mechanical room and utility area to locate main drain cleanout for commercial building. Assessed drainage system including copper piping and condensate lines serving HVAC equipment. Cleared obstruction in main building drain to restore proper flow and prevent water backup that was impacting office air conditioning unit operation. Verified drainage system functionality upon completion.

Completed cooling season tune-up and preventive maintenance on 14-year-old Goodman central air conditioning unit, model CAPF3842D6DB. Performed comprehensive system inspection including electrical components, circuit boards, wiring connections, and control panel; verified all connections secure and operational. Unit tested and found operating within normal parameters for continued reliable cooling performance.

Completed comprehensive cooling system tune-up on 14-year-old residential air conditioning unit. Performed standard preventative maintenance procedures including inspection of outdoor condenser unit, blower motor assembly, and control board with all electrical connections. All components found operating within normal parameters with no deficiencies noted. System tested and confirmed functioning properly upon completion.

Responded to no cooling complaint on 10+ year old residential AC unit located at side of home. Upon arrival, confirmed unit was off with fan running as instructed during dispatch call. Connected Fieldpiece SMAN digital manifold gauges to service ports and performed refrigerant system diagnostics. Measured operating pressures and temperatures, recording high-side pressure of 242.0 psig and low-side pressure reading, with corresponding temperature values displayed on digital gauge. Evaluated system performance parameters through manifold readings to identify root cause of cooling failure and determine appropriate corrective action.

Responded to emergency no-cool call for upstairs 8-year-old Trane unit. Upon inspection of electrical control panel, diagnosed failed dual run capacitor preventing compressor and condenser fan operation. Replaced defective capacitor with manufacturer-specified replacement, verified proper microfarad ratings, and tested all electrical connections. System restored to normal cooling operation with proper amperage draws confirmed on all components.

Responded to kitchen sink clog as drain technician following initial plumber visit. Upon inspection of under-sink cabinet area, verified proper installation and condition of garbage disposal unit, P-trap, and associated drain lines. Successfully cleared blockage and restored proper drainage function to kitchen sink.

Responded to no cooling call on 13-year-old Amana system where indoor unit was blowing air but outdoor unit failed to operate. Upon inspection, found outdoor condenser unit non-operational and thermostat unresponsive to adjustments. Diagnosed electrical failure preventing compressor engagement, performed necessary repairs to restore power to outdoor unit, verified proper thermostat communication, and tested system operation to confirm cooling restoration and proper refrigerant cycling.

Performed complete cooling system tune-up on ground-level backyard unit U10. Inspected and photographed 16x25x1 air filter showing moderate dust accumulation with discoloration in lower section. Accessed control panel to inspect electrical components, circuit board, capacitors, wiring connections, and transformer; all components found in proper working condition with secure connections throughout the system.

Responded to no cooling call on 10-year-old air conditioning system. Upon arrival, performed diagnostic evaluation of electrical components including relay panel and circuit breaker panel. Inspected relay panel wiring connections, terminal blocks, and internal circuitry for proper operation. Verified circuit breaker functionality and electrical supply to HVAC equipment. Documented system conditions with photos of relay panel assembly and electrical distribution panel. Restored cooling operation to residential air conditioning system serving entire home.

Installed a 50-gallon State ProLine natural gas tall water heater in basement utility area. Connected copper supply lines and gas piping to new unit, established proper venting, and verified all connections for code compliance. Obtained City of Kirkwood plumbing permit (PLUM-26-0507) for installation, confirmed unit meets ANSI Z21.10.1-2011 standards, and completed all required safety checks prior to commissioning the water heater for operation.

Completed comprehensive cooling season tune-up on 3-year-old outdoor condensing unit. Performed full system inspection including amperage draw verification using clamp meter (reading 9.82A), accessed and inspected condenser coil condition through side panel, and evaluated fan motor operation. All components found operating within normal parameters with no deficiencies noted.

Responded to service call for rattling noise coming from 10-year-old basement air conditioning unit. Upon arrival, inspected outdoor condenser unit and found heavy accumulation of dirt and debris on front panel and internal components. Removed access panel and thoroughly cleaned condenser coils, fan assembly, and housing. Identified loose mounting hardware on blower fan causing vibration and rattling noise audible through ductwork. Tightened all fasteners and secured fan assembly. Cycled system through multiple operation cycles to verify elimination of rattling noise. Unit operating properly with normal airflow and cooling capacity restored.

Responded to water leak complaint from 10-year-old air conditioning unit located in garage. Upon arrival, performed system inspection and temperature diagnostics on supply ductwork, recording readings of 78.8°F and 73°F at various points along the metal duct assembly. Identified source of moisture concern and assessed overall system operation to determine appropriate corrective action.

Completed comprehensive cooling tune-up on 3-year-old residential AC system. Condenser coils were heavily clogged with dust, dirt, and debris accumulation, significantly restricting airflow through the unit. Thoroughly cleaned and cleared all exterior coil surfaces, restoring proper ventilation and heat exchange efficiency to manufacturer specifications.

Responded to no cooling complaint on residential HVAC system less than 10 years old. Customer reported unit cycling off frequently and failing to maintain setpoint temperature. Upon arrival, advised customer to power down system for safety. Performed diagnostic inspection of air handler unit, accessing interior cabinet to examine electrical components and blower assembly. Inspected circuit breaker panel, control wiring, and blower motor (TEEMAR2C3415CA). Documented system conditions with photos for service records.

Responded to no cooling complaint on 10+ year old residential air conditioning system located on side of home. Upon arrival, performed diagnostic evaluation of HVAC unit and air handler. Inspected system components, checked refrigerant pressures, and assessed overall equipment operation. System evaluated and findings documented with photos of equipment and installation area.

Completed comprehensive cooling system tune-up on a 2-year-old residential AC unit located on side of property. Performed full system inspection, replaced air filter, verified refrigerant levels, checked electrical connections, and confirmed optimal operating performance. Unit is functioning efficiently with no issues identified.

Responded to geothermal system experiencing low refrigerant levels with air handler located in attic. Upon inspection, identified refrigerant loss in the system and documented existing equipment conditions including copper refrigerant lines, valves, and associated mechanical components in the utility area. Noted previous equipment failure documentation marked on system components.

Installed new White-Rodgers digital thermostat in vertical mount configuration to replace existing unit. Thermostat was properly mounted, wired, and tested for both heating and cooling operation. System confirmed operational with thermostat displaying correctly and responding to control inputs.