Plumbing, Heating & Air Conditioning Service in Fenton, MO

Responded to callback for non-operational outdoor unit with condenser fan failure and warm air discharge. Upon arrival, performed diagnostic testing on the dual-run capacitor using Fluke 115 multimeter. Initial capacitance reading measured 45.3 microfarads on common terminal, significantly below manufacturer specifications. Secondary testing confirmed capacitor failure with reading of 577 microfarads out of acceptable range. Identified failed TITAN brand capacitor as root cause of condenser fan motor failure and system malfunction. Replaced defective dual-run capacitor with properly rated OEM equivalent component. Restored power to system and verified condenser fan motor operation and proper amp draw. Confirmed unit cycling correctly with adequate airflow and temperature differential across evaporator coil. System returned to normal cooling operation with all components functioning within specifications.

Completed scheduled heating maintenance tune-up on a 9-year-old furnace system. Performed comprehensive system inspection, verified proper operation of all components, and confirmed heating functionality. Inspected and documented pleated air filter condition showing clean media with uniform gray coloration and proper pleating throughout. Verified Lennox thermostat programming and operation, confirming heat setpoint at 60 degrees and system responding appropriately in away mode. All safety controls tested and operating within manufacturer specifications. System found to be working properly with no deficiencies noted.

Responded to active water leak from failed water heater of unknown age causing property damage. Removed and replaced existing unit with new 50-gallon gas tall water heater. Installation included connecting copper supply lines, gas line, and proper venting per manufacturer specifications. Verified all connections for leaks, tested temperature and pressure relief valve operation, and confirmed proper ignition and burner function. System pressurized and operational upon completion with no leaks detected.

Completed comprehensive Supertune maintenance service on two HVAC systems including furnaces located in basement/crawl space and ground-mounted condensing units in rear yard. Performed full system diagnostics using digital multimeter to verify proper electrical operation, measuring microamp draw and voltage readings on both heating and cooling equipment. Conducted standard preventive maintenance protocol including inspection of all major components, cleaning, filter replacement, and operational testing of furnaces and air conditioning units. All systems tested within normal operating parameters upon completion with no deficiencies noted.

Responded to service call for flickering kitchen light fixture. Conducted comprehensive electrical home audit, inspecting main electrical panel, service meter, and associated wiring systems. Documented electrical infrastructure including panel box with multi-conductor wiring, exterior meter installation with proper conduit routing, and ground wire connections. All critical electrical components photographed for service records.

Completed installation of three ceiling fans in residential property. First unit installed features bronze finish with integrated cage-style light fixture and five-blade configuration, mounted in bedroom with textured ceiling. Second unit consists of traditional chandelier-style fixture with multiple candle bulbs, chain-mounted in kitchen/dining area with crown molding. Verified proper electrical connections, tested fan operations at all speed settings, and confirmed lighting functionality on both fixtures. All installations secured to ceiling joists per manufacturer specifications and local electrical code requirements.

Responded to no cooling complaint on over 10-year-old Lennox system located in side yard with air handler in interior utility closet. Upon arrival, found system blowing warm air and unable to maintain setpoint as reported. Performed diagnostic evaluation of both indoor air handler and outdoor condensing unit, checking refrigerant pressures, electrical components, and airflow. Identified system deficiency preventing proper cooling operation. Provided customer with findings and repair options for the aging equipment. Unit was left in off position per customer's prior instruction pending repair approval.

Responded to service call for 9-year-old A/C system with fan operating randomly when system was off. Inspected control board and wiring connections in furnace cabinet and found faulty relay causing phantom fan calls. Accessed EMERSE control board assembly, tested all low-voltage connections, and verified proper terminal continuity. Documented existing control panel configuration with detailed photography for service records.

Completed professional installation of a 50-gallon tall gas water heater in an unfinished basement utility area. The State ProLine Commercial Grade unit was installed with comprehensive plumbing connections, including copper supply lines, brass fittings, multiple shut-off valves with color-coded handles for system control, and proper venting with gray flue piping. A blue thermal expansion tank was mounted to the system and secured with copper piping to protect against pressure buildup. All connections were properly fitted and sealed to manufacturer specifications, with the unit positioned on a concrete floor for optimal drainage and accessibility. The installation was completed as a cash-on-delivery setup without permit requirements.

Completed preventive maintenance tune-up on single residential air conditioning unit located at side of house. Performed comprehensive system diagnostics including electrical measurements using digital multimeter, recording operational parameters at 46.97 (temperature or voltage reading). Inspected condenser unit exterior components, confirming heat exchanger fins are clean, properly aligned, and free of debris or damage, ensuring optimal airflow and heat transfer efficiency for continued system performance.

Responded to emergency no cooling call for 8-year-old Trane system affecting entire residence. Upon arrival, inspected Honeywell programmable thermostat and verified settings and display functionality. Proceeded to outdoor condenser unit and performed diagnostic evaluation of the system. Documented equipment condition through photographs of both indoor thermostat and outdoor condensing unit for service records. Unit restored to proper cooling operation and system tested to confirm full functionality throughout the home.

Performed comprehensive preventive maintenance tune-up on 5-year-old Lennox HVAC system with no reported issues or symptoms. Completed full system inspection including control board diagnostics, electrical connections verification, air filter assessment, and return air grille examination. All components found operating within normal parameters; system confirmed in good working condition following standard maintenance protocol.

Completed comprehensive Supertune U10 maintenance on 1-year-old Lennox whole-house HVAC system, including both furnace and air conditioning unit. Performed full system inspection, cleaned components, verified refrigerant levels, tested electrical connections, and confirmed proper operation of all equipment. Replaced air filters throughout the system as part of routine preventative maintenance. No issues identified; all equipment operating within manufacturer specifications.

Responded to callback for 1-year-old Lennox system displaying 411 error code and repeatedly tripping. Upon arrival, inspected outdoor unit (serial 5925B07721) and control board assembly with multiple circuit boards and wiring connections. Diagnosed low pressure switch fault causing system shutdown. Documented control panel configuration and wiring for warranty claim, as unit remains under parts and labor coverage through 2028.

Responded to no cooling complaint on 23-year-old residential AC system. Upon arrival, unit had been shut off per prior instruction due to struggling performance. Performed diagnostic evaluation of outdoor condenser unit and indoor air handler system. Given the advanced age of the equipment and reported operational issues, conducted thorough inspection of major components including compressor, condenser coils, refrigerant lines, and electrical connections to assess system viability and identify failure points.

Responded to no cooling complaint on 10+ year old outdoor unit located on side of home. Upon arrival, found system had been shut off with only fan running. Accessed electrical compartment and inspected internal components including capacitor and wiring connections. Thermostat displayed 83 degrees, confirming lack of cooling performance. Documented unit condition with exterior debris present around base and evaluated system for necessary repairs to restore cooling operation.

Responded to no-cool call on 22-year-old Trane system (Model CCBC48A4ACD0) experiencing repeated freeze-ups. Upon arrival, confirmed system was manufactured in 2004 and evaluated operational parameters using digital manifold gauges. Measured superheat at 59.2°F, indicating severely restricted refrigerant flow or low charge condition. Subcooling reading of 12.7°F and pressure readings of 52.9 PSI high-side and 28.95 PSI low-side confirmed inadequate refrigerant charge in the system. Given the age of the unit and the freeze-up symptoms, likely causes include refrigerant leak, restricted metering device, or compromised airflow across the evaporator coil. Documented system nameplate information and current operating conditions with photos for service records. Advised customer of findings and recommended options for repair versus replacement given the system's age exceeding typical equipment lifespan.

# HVAC Supertune Service Completed Performed comprehensive supertune maintenance on residential air conditioning system per Home Depot work order HD#F61837123. No customer-reported issues or symptoms at time of service. System age undetermined. ## Work Performed Conducted complete system inspection and diagnostics on outdoor condensing unit and indoor air handler. Performed electrical testing using Fieldpiece SC680 True RMS multimeter to verify proper amperage draw and voltage readings across system components. All electrical measurements within manufacturer specifications. Inspected indoor blower motor assembly and compartment. Verified proper operation of blower motor and associated control board components. Checked all electrical connections, wire routing, and safety controls for secure mounting and proper function. Inspected heat exchanger area and surrounding components for any signs of wear or damage. Performed standard supertune procedures including cleaning condenser coils

Completed comprehensive site assessment for outdoor lighting installation estimate. Evaluated existing front porch decorative wall-mounted lantern fixture with scrollwork design and assessed electrical service infrastructure including meter base, disconnect box, and associated conduit routing. Documented current conditions of exterior lighting system and electrical service equipment to provide accurate scope and specifications for proposed outdoor lighting upgrades.

Completed heating maintenance tune-up on a 9-year-old furnace system. Performed comprehensive inspection of all heating components, verified proper system operation, and took electrical voltage readings using diagnostic meter showing 359V AC. System was found to be functioning properly with no issues identified during the preventative maintenance service.